| Customization: | Available |
|---|---|
| After-sales Service: | Online Service |
| Warranty: | 1 Year |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
QUICK DETAILS
RCA Tape Abrasion Tester is suitable for abrasion test of various surface coating (electroplating, baking paint, screen printing, etc.)
This product conforms to ASTM F 2357-04 standard and is suitable for plastic surface coating wear resistance test. It is mostly used for mobile phone key printing, mobile phone case, MP3, CD player, DVD player, laptop computer, PDA, and electrical appliance case. It has become the most widely used instrument for surface abrasion resistance testing of various plastic coating products.
Use RCA-specific paper tape, apply a fixed weight (55g, 175g, 275g) to the surface of the sample to be tested, use a fixed diameter roller and constant speed motor, and match a specific counter to determine the number of times the sample can withstand the wear In order to determine the wear resistance of the product
INSTRUCTIONS
1. Scuffing non-oiled paper or tape with the sample rubs at a certain number of revolutions,deciding its wear-resistance effect.
2, for the softer material to reduce the load of 55g or 175g
3, two sample fixation options
4, with a magnifying glass to view
5, counter: LCD display, 0-999,999 (set times)
PRECAUTIONS
1. The test paper must be dedicated and cannot be arbitrarily replaced
2. Please put the paper into the oven before use, and bake at 60 degrees for 30 minutes.
3. Check whether the screen data is correct at any time during the operation of the machine
4. The machine should be unplugged when not in use
TESTING PROCEDURES
1. Install the tape: Remove the alloy disc on the right paper pulley of the tester, fix the paper tape, and then lock the alloy disc.
2. Body level correction: Refer to the spirit level of the spirit level by referring to the spirit level, that is, the water drop in the middle of the level meter must be in the middle position. If it is not in the middle, it can be adjusted to the level by the four feet at the bottom of the machine.
3. Fix the object to be placed on the platform (the object to be measured should be directly below the test roller). Use double-sided adhesive or hot melt adhesive to fix the small roller on the surface to be tested. After adjusting the height of the small platform to make the horizontal bead horizontal, lock the small platform to prevent it from moving during the test.
4. Turn on the power, reset the counter, and set the number of operations for products of different specifications.
5. Pass the tape along the bottom of the right guide roller --> the surface of the object to be measured --> the roller carriage --> (put the tape into the roller carriage when the machine is running). Under the left guide roller , Finally, the paper tape is fixed on the delivery tray.
6. Turn the ON/OFF power switch to the ON position and the counter will start counting.
7. Accumulation of detection times: When the preset number of rotations of the drive wheel has not yet been able to detect the print life, the detection action can be continued. At this time, just press the reset button, the machine will automatically run the number of rotations set before (Note Can not replace other detection products), and automatically record the total number of driving wheels.
8. The test is completed: take out the measured object, clean the test table, reset the count screen, and cut off the power switch.
TECHNICAL PARAMETERS
| Number of motors | Dual motor drive, running more smoothly. |
| Testing Load | There are 55g, 175g, 275g three options,for different degrees of soft material or different test conditions. |
| Counter | 0~9999 times (digital display), rotary counter |
| Test rate | 2670mm/min 157mm/cycle, continuous operation |
| Machine speed | 17 r/min |
| External dimensions | 800*300*380mm (L*W*H) |
| Power supply | AC220 50/60HZ |
){kind=link}